Please login or register.

Login with username, password and session length
Pages: 1 [2]

Author Topic: Newbie Looking for help  (Read 10679 times)

Tuicemen

  • Administrator
  • Hero Member
  • ****
  • Helpful Post Rating: 282
  • Posts: 10497
  • I don't work for X10, I use it successfuly!
Re: Newbie Looking for help
« Reply #15 on: April 15, 2012, 07:06:38 AM »


I still cannot get this to work. My security console in set to housecode A. I have lamp modules controlling security lights on A1, A2 and A3. I was planning to use A4 for my camera trigger. I have set the SW Security consol House code to A. The bottom section of the SW setup screen says it is not for signals from the security console. Where do I set my A4 for a Universal Module?
Sorry I missed this!  :-[
Your universal module can't be on house code A as that is the house code the console is sending Alllights On/ AllUnits Off signals
The module you wish to turn on must be a different house code and is the fist unit code of that house code
Use SpecifyX10Code to send RF on signal with alarm see attatched.( I used B1)
You Could however trigger a PCC Command to do most anything.
« Last Edit: April 15, 2012, 07:08:30 AM by Tuicemen »
Logged
Please Read Topic:
General Forum Etiquette
Before you post!
Pages: 1 [2]
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.