Please login or register.

Login with username, password and session length

Author Topic: Vanguard Rundll problem  (Read 25987 times)

jinks

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 2
Vanguard Rundll problem
« on: May 16, 2012, 10:12:53 AM »

Hey Im new here but I've been lurking on this forum for awhile. I just got a new computer and I've got two issues. Whenever I go into options and change something then press ok I get the rundll problem message. I've looked around and found no other problem like mine. The second problem is with the CM19A transceiver. Windows installed it and says its running fine. But, the vanguard software refuses to recognize it. I've tried uninstalling it and then reinstalling it and had no luck. I went to the x10 software site and installed the software for the driver and still had no luck.

Im running everything on windows 7 64bit. Any help will be appreciated.
Logged

Dan Lawrence

  • Hero Member
  • *****
  • Helpful Post Rating: 68
  • Posts: 3991
Re: Vanguard Rundll problem
« Reply #1 on: May 16, 2012, 03:55:32 PM »

I suspect the Vanguard software was built for the CM15A, not the CM19/TM751 combine.
Logged
I don't SELL this stuff... BUT I sure do ENJOY using it!!!

jinks

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 2
Re: Vanguard Rundll problem
« Reply #2 on: May 17, 2012, 12:31:14 PM »

I got it working flawlessly on my xp. And I got those problems solved on the new computer. I just had to download a new driver and it worked. But now it won't scan through all of the cameras? Got any Ideas? Im thinking about hooking them up to motion detectors now. Instead of just scanning through all of the cameras.
Logged

cowboy

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 1
Re: Vanguard Rundll problem
« Reply #3 on: January 19, 2013, 08:39:17 PM »

Which drivers did you download?
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.