Running Vanguard twice on the same computer?

[jflynn]

I already have a system setup and running (for a couple years) that is running at 2.4Ghz.

I recently made another purchase of what I thought was the same system but turned out to be run at 900Mhz. 

Since these systems/cameras can not run on the same receivers, can I set up both systems to run at the same time on the same computer?

[Dan Lawrence]

Only if both are in different folders on the same machine and both cannot be on at the same time.

[jflynn]

Crap, I'd need both of them to be running at the same time. 

[Tuicemen]

Crap, I'd need both of them to be running at the same time.  

Why can't you use a Y splitter so your VA12/13 connects to both receivers?
That way you only need one instance of the software running.
You'll need to turn on the appropriate receiver for cams when switching.
I don't know if this is possible with vanguard but it is with AHP macros and the camera plug-in

[jflynn]

I thought about trying the use of a splitter but I think I would have a problem with it auto scrolling through the cameras.  Manual switching would probably work.

[Tuicemen]

Using an AHP macro and Iwatchout wouldn't be a problem.
When a signal was detected to turn on a 900MHz cam it would turn on the receiver for it and send a signal to turn off the 2.4GHz receiver.
I have a  macro do a similar task with wired and wireless cams

[jflynn]

um, where do I find these things?

that would be great.

[Tuicemen]

AHP
iwatchout