Please login or register.

Login with username, password and session length

Author Topic: CM19A and SR731  (Read 1466 times)


  • Jr. Member
  • **
  • Helpful Post Rating: 0
  • Posts: 16
CM19A and SR731
« on: February 21, 2013, 02:57:46 AM »

I was wondering if the CM19A will receive the retransmitted signal from a SR731.  In some posts from about 2 years ago it seemed like it might.  I just got a CM19A as part of the MyGarage package.  Unfortunately the location I want to use it at is outside the range of my currently installed CM15A.

I was thinking that if the CM19A will respond to the SR731 that I can connect the CM19A to my PC where I have the ActiveHome Pro software installed and put the SR731 about halfway between the garage and the computer.  I have already modded the Antenna setup for the CM15A and will not get any additional range out of it AND the CM15A will not receive a rebroadcasted  signal from the SR731.

I am asking because I have tested this and it seems like the SR731 is receiving the signal from the garage and is resending it... But it never shows up at the AHP...  Could it be that the CM19A reception is so bad that it is not receiving the signal or is it just not understanding it at all?



Brian H

  • Community Organizer
  • Hero Member
  • ***
  • Helpful Post Rating: 301
  • Posts: 13106
Re: CM19A and SR731
« Reply #1 on: February 21, 2013, 06:05:47 AM »

SR731 is discontinued and has not been available for a fairly long time.
It was also known to have problems properly repeating some commands.

Dan Lawrence

  • Hero Member
  • *****
  • Helpful Post Rating: 68
  • Posts: 3991
Re: CM19A and SR731
« Reply #2 on: February 21, 2013, 09:41:40 AM »

I would suspect that a CM15A and the CM19 package would clash with each other.  The CM19 package was created when there was a total shortage of the CM15A.
I don't SELL this stuff... BUT I sure do ENJOY using it!!! | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 All rights reserved.