Contact | X10.com
Please login or register.

Login with username, password and session length

Author Topic: Multiple RX569 connected to RX549  (Read 1503 times)

toddinpal

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 2
Multiple RX569 connected to RX549
« on: March 18, 2013, 11:29:09 AM »
Using a splitter, would connecting two RX569 infrared extenders work when connected to an RX549?  Not sure how much current the RX569 consumes or the RX549 and produce.  I'm assuming the RX569 is essentially just an IR LED.

Regards,
Todd
Logged

dave w

  • Community Organizer
  • Hero Member
  • ***
  • Helpful Post Rating: 139
  • Posts: 6116
Re: Multiple RX569 connected to RX549
« Reply #1 on: March 18, 2013, 12:11:43 PM »
Quote from: toddinpal on March 18, 2013, 11:29:09 AM
Using a splitter, would connecting two RX569 infrared extenders work when connected to an RX549?  Not sure how much current the RX569 consumes or the RX549 and produce.  I'm assuming the RX569 is essentially just an IR LED.
I have Powermid and although never tried a second extender  it should work (yes it is just an IR LED on a cable), but probably at lower output. Just make sure your second extender is either a RX569 or at least wired the same.
Logged
"This aftershave makes me look fat"

toddinpal

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 2
Re: Multiple RX569 connected to RX549
« Reply #2 on: March 18, 2013, 12:16:58 PM »
Hi,

Yes, I was going to use another RX569 wired in parallel.  as I say, my main concern is whether the RE549 provides enough current to drive another LED.

Regards,
Todd
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.