Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[IndiX10]

I replaced an LX-318 screw in light control with an LM15A when it stopped working.  The standard Lm15A programming with 3 button presses is not working.  Any ideas on getting this to work or I have to stay with the 318 series parts?
Thanks

[timlight10]

If the Default Address at "A1” is acceptable in your application, you do not need to program the LM15A at this time. Programming the
LM15A Lamp Module to a new Address: 1. Observe above diagram, obtain a standard table lamp, a PMC01 Mini-Controller or Equivalent. (This is
easiest and most reliable method). 2. Install a 40W or higher Incandescent Bulb into the lamp socket, turn-on the lamp, ensure bulb is working turn the
lamp switch off. 3. Remove bulb from lamp socket, install the bulb into the LM15A, install the LM15A Screw-in Lamp Module into the lamp socket. 4.
Plug the Mini-Controller (PMC01) into the same outlet as the lamp. 5. Set the X10 Controller to the House Code (A-P) that you desire the LM15A to
respond to. 6. Turn the lamp switch On, applying power to the LM15A. 7. Press the "ON" Button on the Mini-Controller (corresponding to the Unit
Number that you want the LM15A to respond to), 3 times, at about 1 second intervals. On the third press the bulb will turn on, signifying that the Code
has been learned / programmed. 8. The LM15A can now be removed from the lamp and installed in its normal location in the home. Be sure to
observe the Electrical Protocol, above, for proper remote operation with an X10 Controller. Note: The LM15A can be used outdoors only if mounted
into a downward pointed socket.