🛡Home Security > Home Security General

SC1200: SecuriLINK Home Security System Zone #1 alert

(1/2) > >>

TURBOGNX:
Just recently my SC1200 comes up with "Zone #1" and a fast dinging when I try to set the alarm (home or away). I have checked all my sensors and they all trigger a bell when you open them. I unplugged the system and took out the backup batteries, put them back in and plugged it back in and the system works.......but once I disarm it I am right back to the zone #1 warning the next time I try to arm it. B:(

Brian H:
Was the display Zone 1 Open message, when you tried to arm it?
Is there any other Zone 1 messages like Trouble on Zone 1?
When Zone 1 is closed. Is the small #1 still being displayed on the console?

TURBOGNX:
No it just says zone 1.
No other messages.
I can open any of the doors and it never displays that a zone is open.
Up above where it says "Home Control" it looks like there is a small 3 or 5.

Brian H:
I am sorry if I was not too clear.
When the SC1200 is not armed and you are not trying to arm it. The small numbers around the edge indicate the console sees that zone is open. That 3 or 5 may indicate the console thinks that zone is open. If you open and close a zone. You should see the numbers go on and off. If the chime function is enabled it should also chime when the zones is opened.

The Problem Zone display shows when you try and arm it and it see a Zone as Open.
Trouble Zone would indicate a zone has not checked in within four hours. The sensors send a heartbeat message about every hour. If four in a row are missed. The console flags a Trouble Zone.
Tamper Zone would be someone opened the cover on a sensor and it sent a Tamper Message.

TURBOGNX:
It looks like the SC1200 is seeing 6 zones but I only have 5 zones. Is there any way to delete that extra zone?

Navigation

[0] Message Index

[#] Next page