New 64bit HP Desktop and installed AHP

[bille57182]

AHP is not using the CM15A after install.  Plug it in and driver is installed but does not pass signals to modules.  Any assistance would be appreciated.  It would be great to have a working system again.  If I plug in the CM19A AHP will control the lights but that is not optimal.

[Tuicemen]

Are all signals not being sent from AHP via the CM15 or just lights?
Have you set up which house codes to transceive ?
Have you cleared and updated timer and macros on the interface (Cm15a)?
If you use a palm pad or remote will the Cm15a relay the commands?