CM19A not transmitting???

Started by liderbug, February 16, 2015, 11:04:51 PM

Previous topic - Next topic

liderbug

Raspberry Pi running mochad with a CM19A.

When I
  echo "rf e3 on" | nc 127.0.0.1 1099

mochad echos time Tx RF HouseUnit: E3 Func: On
but e3 does not turn on.  The TM751 is about 20' away and I have a CM11A plugged in also and it doesn't see the CM19A outgoing command. 

Anybody???
Thanks
cal


Brian H

The TM751 is set to House Code E?
You may want to rotate the House Code Dial on the TM751 a few times. On the chance it is dirty and it is on a different House Code.

If your TM751 has the controlled outlet on it {there was a production run with a hard wired pass through outlet}. If you send an E1 On and an E1 Off. Can you control the TM751s output?

SMF spam blocked by CleanTalk