Please login or register.

Login with username, password and session length

Author Topic: SC1200 Problem?  (Read 8621 times)

rlcohen7

  • Full Member
  • ***
  • Helpful Post Rating: 0
  • Posts: 30
SC1200 Problem?
« on: December 23, 2017, 01:59:27 AM »

I have an X-10 system (door, window sensors, motion detectors etc) for many years and an SC1200 consol. I armed the system before I left my home for the winter. Yesterday, my grandson went to check on my home. He tried to disarm the system from outside the door with a keychain remote that I had properly linked and checked a couple of weeks ago before I left. It did not work, so when he opened the door, the alarm sounded. He then tried to disarm standing next to the consol, with the remote, using the consol itself and using an old IBM remote (all of which worked previously) all to no avail. I was on my cell phone with him and had him pull the plug on the consol and remove its batteries to stop the alarm. Coincidentally, my landline phone, connected to the consol and programmed to call my cell on an intrusion was out of service due to Verizon changing from copper to fiber. Are these two things connected and what do you think caused him to be unable to disarm the system?
Logged

Brian H

  • Community Organizer
  • Hero Member
  • ***
  • Helpful Post Rating: 305
  • Posts: 13295
Re: SC1200 Problem?
« Reply #1 on: December 25, 2017, 10:53:40 AM »

After he powered it down and removed the batteries.
How did it act after a power restore?

I have seen some reports of land lines on fiber or cable interfaces. Not dialing out correctly.
Though I don't know if no phone would cause such issues.
I don't think so. As I have tested a few with no phone connected.
Was it ever tried in the new Verizon fiber interface and did it work?
« Last Edit: December 25, 2017, 10:56:35 AM by Brian H »
Logged

rlcohen7

  • Full Member
  • ***
  • Helpful Post Rating: 0
  • Posts: 30
Re: SC1200 Problem?
« Reply #2 on: December 25, 2017, 01:38:13 PM »

The unit was not powered up again. I will have to investigate further when I return to that location in three months. I had to suspend land line service there until I get back and allow a tech in to either repair the copper line or convert to fiber. Then i'll power up the SC1200 and relink all the sensors to it and see if the system works again. Is the Sc1200 compatible with Verizon FIOS?
Logged

Brian H

  • Community Organizer
  • Hero Member
  • ***
  • Helpful Post Rating: 305
  • Posts: 13295
Re: SC1200 Problem?
« Reply #3 on: December 25, 2017, 02:21:28 PM »

I don't know if it is compatible.
There where others here with Verizon FIOS. That should have more information for you.

I had seen a post where adding a DSL filter on the cord to the SC1200 sometimes helped.

Will be interesting to see how it acts when you redo the setup.
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.