Topic: Soft start dimmer won't remote dim after XPRESET command (Read 1785 times)

PatPend · « **on:** February 18, 2016, 07:23:39 AM »

I have a few X10 soft start wall modules (X10 PRO XPS3/WS13A) controlled via a CM11A. The modules are turned on using an xpreset command to a pre-set dim level. If I later try to remote dim one of these modules up/down, it will not respond to the dim command. If I manually turn the module on, remote dim works fine. If I send a regular on command, then dim, dimming works, but then the preset on level is the last level the module was at, not the preset level. Wondering if this is a bug or a feature and if anyone has ideas on workarounds. Thanks, Russ

Brian H · « **Reply #1 on:** February 18, 2016, 07:36:57 AM »

I am not sure if any of the information in the X10 wiki page may help you but you may find some information in it.
http://kbase.x10.com/wiki/Newer_Wall_Switches_and_Preset_Dim

News:

Author Topic: Soft start dimmer won't remote dim after XPRESET command (Read 1785 times)

PatPend

Soft start dimmer won't remote dim after XPRESET command

Brian H

Re: Soft start dimmer won't remote dim after XPRESET command