🛡Home Security > Home Security General

Arming Security Console from CM15a

<< < (2/3) > >>

racerfern:

--- Quote ---As long as you have the OnAlert running with the AHP on a PC... your good to activate.
--- End quote ---

I have OnAlert active and I've never been able to do anything with the SC1200 other than watch its state. I can't change it or even see a place to arm or disarm. What am I missing?

Tuicemen:
If I remember right you need to set up a security remote In macro settings you go to security the option is there.

lviper:

--- Quote from: Tuicemen on December 31, 2016, 07:55:45 AM ---If I remember right you need to set up a security remote In macro settings you go to security the option is there.

--- End quote ---

Correct, you do need to have one of your security remotes setup in AHP. Then in macros under Security where you select Rooms you will have the options to arm and disarm. But you need to install one of the security remotes programmed in to the security console in to AHP. AHP will use the code from that remote to arm and disarm the console.

HA Dave:

--- Quote from: lviper on January 02, 2017, 08:39:17 AM ---........security console in to AHP. AHP will use the code from that remote to arm and disarm the console.

--- End quote ---

Disarm? I don't recall disarm being an option in OnAlert.

Tuicemen:

--- Quote from: HA Dave on January 02, 2017, 12:19:13 PM ---
--- Quote from: lviper on January 02, 2017, 08:39:17 AM ---........security console in to AHP. AHP will use the code from that remote to arm and disarm the console.

--- End quote ---

Disarm? I don't recall disarm being an option in OnAlert.

--- End quote ---
yep arm and disarm are both there  ;)

Navigation

[0] Message Index

[#] Next page

[*] Previous page