📱X10 WIFI > 🧾Wish list

Please add ability for app to work with more then one x10 Hub!

(1/8) > >>

Tuicemen:
Currently the app will only work with one WM100. I expect this to change shortly as it was one option I put forward in tests.
The reason is I have a summer cottage and would love to access it  as well as my city residents.
Other hub apps have this ability, and it is the hub that holds the device info not the app.

Another reason is these are limited to 32 devices which is fine for most users but power users may require control of more then 32 ( not sure why the limit if it the memory onboard was to be better then the CM15) ::) :'
I'm still waiting for the specs to see if the other limits I found in testing are still there.

dave w:
Only 32 devices??? Not good. Change my vote from "one is enough" to at least 2. I have 86 devices. I have full control of all my devices through the Homeseer server so 32 isn't a show stopper at all. But I like the Apps ability to organize under Rooms.

Tuicemen:
I added the ability to change your vote.
Just clck remove vote the re-vote ;)

Knightrider:
I run 5 wifi networks in this house. Would be nice to have a WM 100 on each network.

Tuicemen:
Ok this one got some attention at Authinx :)% :)%
They have been in contact with the developer to see how this might be accomplished.
Since I have two Rm Broadlinks which can both be controlled from one app on one phone I put forth they use a simular method.
other users with more then one HUB from a different vendor may have another suggestion.
I put this here for the developer:
The App asks you to register a Hub you can name it or let the app do that.(since the WM100s are already in use this could be auto named with the next app update)  you can add remove hubs at any time as well as change the names any time. When you start the App it connects to the last hub you were connected to if you wish to use another you select which one.
Syncing only happens with the hub the app is told to use.
You can switch between Hubs at any time since sync happens on first connect this should not be a problem.
 >!

Navigation

[0] Message Index

[#] Next page