Contact | X10.com
Please login or register.

Login with username, password and session length

Author Topic: 3 way dimmer switch  (Read 2011 times)

scali2018

  • Full Member
  • ***
  • Helpful Post Rating: 0
  • Posts: 31
3 way dimmer switch
« on: March 22, 2018, 08:45:27 AM »
Do you need to use x10 companion switches with a 3-way dimmer set up, or are the standard switched ok to keep in place?   What would be the issue if the x10 dimmer is on a slave circuit versus the main?

thanks in advance for you help.
Logged

bkenobi

  • PI Expert
  • Hero Member
  • ******
  • Helpful Post Rating: 24
  • Posts: 2082
Re: 3 way dimmer switch
« Reply #1 on: March 22, 2018, 10:16:48 AM »
If you are asking if you can remove the companion switch and just use the main switch, then I have done it and it seems to work.  I wouldn't design it that way since it's a bit of a waste.  There are newer switches that work this way and are documented too (e.g., WS469).
Logged

scali2018

  • Full Member
  • ***
  • Helpful Post Rating: 0
  • Posts: 31
Re: 3 way dimmer switch
« Reply #2 on: March 22, 2018, 11:16:02 AM »
Thanks for the reply. I don't think I was very clear on my question.  I am wondering if I can keep the old (leviton) companion switches and just replace the main switch with the X10.  I know x10 sells the companion switches, but I wonder if they are necessary, and if so what do they do that a standard leviton switch doesn't?
Logged

Brian H

  • Community Organizer
  • Hero Member
  • ***
  • Helpful Post Rating: 305
  • Posts: 13295
Re: 3 way dimmer switch
« Reply #3 on: March 22, 2018, 05:16:32 PM »
Is the Leviton companion switch a mechanical standard type or the Leviton companion switch for their automation line of switches.
If it is a standard mechanical one. Yes it has to be replaced with an X10 one.
It is different. It does not switch between two traveler wires between the switches in a three way setup. It connects AC line to the control input on the X10 switch when you momentarily push it. As it is a momentary type switch.

Here is the instructions for the WS4777/CS277 three way switch set.
http://www.authinx.com/manuals/X10/WS4777-CS277.pdf

The standard X10 WS467 switch will not work with the CS277 Companion as it has no control input wire. So no three way.
http://www.authinx.com/manuals/X10/ws467.pdf

The Decorator style WS12 dimmer, WS13 Relay On/Off both have a control input and can be used in a three way with a WS14 Companion.
http://www.authinx.com/manuals/X10/WS12A.pdf
http://www.authinx.com/manuals/X10/WS13A.pdf

WS469 Relay On/Off type. Needs a Neutral power connection.
http://www.authinx.com/manuals/X10/ws469.pdf

« Last Edit: March 22, 2018, 06:32:50 PM by Brian H »
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.