📱X10 WIFI > 🗯General Discussion

All Lights On vs All Lights On?!

<< < (2/2)

Brian H:

--- Quote from: VinRin57 on June 08, 2018, 05:55:02 AM ---TM.. I did some further testing and it looks like the interface is not working at all.
Doesn't turn anything on or off....

Before I get the bug and replace it, it appears that if set at mode 3, it 'should' turn on and off that specific address, correct?

Would that indicate anything regardless of module type?

--- End quote ---

Yes mode 3 sends an On when triggered and Off when the trigger is removed. The TEST button should also sent an On when pushed and an Off when when released. Any X10 module on the House Code and Unit Code sent by the PSC01. Should go On and Off.

Found the PSC01 manual if you need it.
http://www.authinx.com/manuals/X10/PSC01.pdf

The WS13A manual indicates. Will respond to an All Lights On command on its House Code.
http://www.authinx.com/x10/manuals/WS13A.pdf
Your finding it controls nothing may also indicate it has failed.

VinRin57:
Thanks Brian...

I think you nailed it.. finding nothing is responding pretty much indicates it's failed. 

I did look over the manuals and with nothing happening, and changing modules over the years, led to the question... 
I guess I should test these things more often!

Thank you again...

Maybe time to consider a new alarm all together?

Navigation

[0] Message Index

[*] Previous page