Contact | X10.com
Please login or register.

Login with username, password and session length
Pages: 1 [2]

Author Topic: USB cable from Pi zero W to CM15A question  (Read 5221 times)

bkenobi

  • PI Expert
  • Hero Member
  • ******
  • Helpful Post Rating: 24
  • Posts: 2082
Re: USB cable from Pi zero W to CM15A question
« Reply #15 on: January 22, 2020, 11:00:36 AM »
The USB standard covers communication specifics.  There is a controller that takes care of timing of this based on the standard.  So long as the wire doesn't cause an issue, the USB host and device will communicate based on the controller.  The CM15A is 1000 years old and does not use USB 3 (probably not even USB 2 actually).  If you have a USB cable that is less than 16' I wouldn't worry about any of this.
Logged

brobin

  • Hero Member
  • *****
  • Helpful Post Rating: 160
  • Posts: 1458
Re: USB cable from Pi zero W to CM15A question
« Reply #16 on: January 22, 2020, 04:35:16 PM »
When I was running Alex10 from a laptop, the USB cable to the CM15A was actually an 8' cable plugged into a 15' extension for a total run of 23ft and I had no problems.  I now use that same cable from a Smartenit P2 to a Smarthome 2413U PLM.
Logged
Pages: 1 [2]
« previous next »
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.