Please login or register.

Login with username, password and session length
Pages: 1 2 [3]

Author Topic: Disabling an X10 Security Sensor temporarily  (Read 4177 times)


  • PI Expert
  • Hero Member
  • ******
  • Helpful Post Rating: 26
  • Posts: 1743
Re: Disabling an X10 Security Sensor temporarily
« Reply #30 on: May 28, 2020, 01:55:19 PM »

I was originally using the X10 motion sensor but it was unreliable and the signal was crappy - the security sensor works much better, so at least for me its a better fit.   I may pick this back up again later but for now I'm not looking to make any more changes with it.

Fortunately the 433mhz sensors and the CM19E don't pose the same problem. TX/RX signal is excellent here. Assuming you are using a CM15a I've seen a few mods here that could improve your TX/RX range on your setup. They might be worth trying.
Pages: 1 2 [3] | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 All rights reserved.