Please login or register.

Login with username, password and session length

Author Topic: Correct designation for 3 way wall switch  (Read 3192 times)

crgross1

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 6
Correct designation for 3 way wall switch
« on: April 18, 2022, 09:20:31 AM »

This 3 way switch is definitely an older soft start type. It previously was setup and used in a macro but
somehow that programming was lost and now I am unable to find the correct X10 designation for this
switch. It will respond to unit C4 via a maxi controller command but not any of the designations I tried to use to program it into the CM15A.

Any and all suggestions gratefully accepted !

literally I have tried all the following module designations attempting to get this switch to respond:
WS467  WS4777  WS13 A-L  PLW02  PLW01   LM365   WS12A   XPD3  XPD13
Logged

Brian H

  • Community Organizer
  • Hero Member
  • ***
  • Helpful Post Rating: 305
  • Posts: 13295
Re: Correct designation for 3 way wall switch
« Reply #1 on: April 18, 2022, 10:05:44 AM »

Older? Before 2007 I believe.
The older ones where not Soft Start and Preset Dim.
If they turn On and Off instantly they are not Soft Start.
If they ramp On and Off slowly then they are Soft Start.

If it is a Soft Start and you have AHP.
Use the drop down list 'Lamps'. They are the ones that have Soft Start and Resume Dim.
The 'Older Lamp (Before Soft Start)' are the ones with no soft Start.
http://kbase.x10.com/wiki/Newer_Wall_Switches_and_Preset_Dim
« Last Edit: April 18, 2022, 10:18:04 AM by Brian H »
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.