📱X10 WIFI > 🗯General Discussion
Looking for User's Manual for a testerlinc
glacier991:
Dragged my old testerlinc out of a box to use it, but somehow it got separated from it's manual. I can get it to work but would think I might benefit from the info in tat manual. Zilch comes up in an online search. Anyone know where I place my hands on one?
Thanks, Chris
Brian H:
4819 TesterLinc .
1132B normally supplied power and interface to the TesterLinc. I stared with the kit of both the 4819 and 1132CU.
I have other information for the 1132B. Like for the old program they used to use it connected to a computer.
glacier991:
Brian! Well another X10/UD'er. I noticed when I came back over here that there were quite a few of us (Paul Bates comes to mind)
Anyway I have the Insteon 1132 and testerlinc all hooked up, just not sure how to interpret the results exactly. I assumed at one point the tested kind came with some documentation explaining all that.
You came up with exactly what I needed (again).
Btw, thanks for your help here and over at the UD forum!
Chris
Brian H:
You are welcome.
I just got mine back out and did some testing myself.
I have a WGL Designs V572A all address RF receiver.
In to the TW523 emulation port on a XTB-IIR
I get a BCY Bad 3 Cycle Gap. Between valid X10 messages. As my UR19A and HR12 send multiple messages when used.
In my case. I think it is normal.
My Insteon modules are from the early days and have an X10 address added to them.
As are a few X10 modules I still have in use. Like a Large Powerhorn, Powerflasher and Socket Rocket.
Triggered by my Boiler's contact closure. On a safety shut down.
glacier991:
Thanks
My V572A is plugged into a XTB-523 up in the attic. My XTR-RII's TW523 emulation port is unused, not sure what use I might find for it.
Hard to totally abandon a protocol that works for you and that you have a decades of experience with. So far I have only a couple Insteon
devices I have forced an X-10 address on, and that i
s due to the distance I can punch an X-10 command thanks toJeff Volpe. Those have yet to be installed and tested as they involve out of house enclosures and it is winter in Montana.
I'll look for the BCY errors and le you know.
Navigation
[0] Message Index
[#] Next page
Go to full version