🖥️ActiveHome Pro > ActiveHome Pro General

Floodlight Motion Sensor (sending continuous PLC)

(1/3) > >>

SteveRF:
I have a PHS01 Flood Motion Sensor that is
set to House code D1.  Three "mornings" in a
row now I have noticed a bad slowdown in
response from motion sensors and the CM15A.
I traced the problem (by way of the Activity
Monitor) to a continuous stream of PLC's
being sent from the Flood Sensor.  Seems the
unit was sending a D6 (dusk code D1+5) in
the morning after the expected dawn code was
sent.  The only way to stop the stream was to
shut power off to the unit from a breaker
(unit is hard wired per specs).  After a
power reset, the erroneous transmissions
stopped.  This has occurred 3 mornings in a row.
Anyone else experiencing this problem ?
Regards,
SteveRF

Observer:
I just can't imagine that, I must be sooo
luckey,  mine just performs as it is suposed
to it just works and works and works and
doesn't misbehave for a whole year now!
Ever since I disconnected it is has behaved
as expected.

PHS01:
I've seen this once with mine and had to
readjust the motion sensor where the sun
wasn't directly hitting the sensor.  The
sensor is very sensitive to direct sunlight
and even extrem temps.

SteveRF:
PHS01,
Mine is under a rear deck cover and it was
cloudy this morning. This was the 3rd day in
a row that the unit decided to start sending
a dusk code plus 5 in a continuous stream.
I have the dusk sensitivity set all the way
to dark so the light wont come on until it is
almost dark.  This happens only in the
morning... it makes my whole system slow to a
crawl and become unreliable.  o well... we
shall see what happens tomorrow morning.
SteveRF

roger1818:
My guess is you have a faulty PHS01.

Navigation

[0] Message Index

[#] Next page