Topic: 2 prong appliance module only works on C1 (Read 27827 times)

showson1 · « **Reply #15 on:** January 03, 2006, 03:14:05 PM »

Hey Brian,
Actually the RTM75 does turn on and off via
the power line signal. I have it set for
housecode C and if I send on or off signal
(through RF or from the PC with CM15A
connected) it goes on and off.

Wonder if that's a difference between it and
the TM751?

roger1818 · « **Reply #16 on:** January 03, 2006, 03:42:51 PM »

showson1: The CM15A has an RF transmitter and
the AHP software is smart enough to know that
to control a TM751 (and presumably a RTM75)
that it must send a RF ON and OFF commands.
You would have to either configure the RTM75
as an appliance module in AHP or use a
plug-in controller to verify if it responds
to powerline commands.

Brian H · « **Reply #17 on:** January 03, 2006, 03:47:07 PM »

Maybe different then as the TM751 only does
RF.

News:

Author Topic: 2 prong appliance module only works on C1 (Read 27827 times)

showson1

Re: 2 prong appliance module only works on C1

roger1818

Re: 2 prong appliance module only works on C1

Brian H

Re: 2 prong appliance module only works on C1