Contact | X10.com
Please login or register.

Login with username, password and session length

Author Topic: Suddenly the Interface is not recognised.  (Read 2395 times)

gary

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 4
Suddenly the Interface is not recognised.
« on: January 25, 2006, 09:24:46 PM »
I added my first sets of commands to the
cm15a and it was working well.  I wanted to
add more commands.  I unplugged the
interface and brought it up to the
computer.  Plugged into outlet then plugged
USB into computer.  I get "USB Device Not
Recognised".
Ideas anyone?
Logged

murphy

  • Sr. Member
  • ****
  • Helpful Post Rating: 1
  • Posts: 77
Re: Suddenly the Interface is not recognised.
« Reply #1 on: January 25, 2006, 10:22:52 PM »
Disconnect USB cable.
Disconnect unit from outlet.
Remove batteries.
Wait a couple of minutes.
Test batteries to make sure they are not weak.
If in doubt, use new batteries.
Put batteries into unit.
Reconnect unit to outlet.
Reconnect USB cable.
Logged

anonymous

  • Guest
Re: Suddenly the Interface is not recognised.
« Reply #2 on: January 25, 2006, 10:46:38 PM »
These instrustion should be on a label
attached to the USB cable!

Gezz ... Gary, Don't you know they learned
this from windows. (Ctrl, Atl, Del & reboot)
Logged

gary

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 4
Re: Suddenly the Interface is not recognised.
« Reply #3 on: January 26, 2006, 08:27:23 AM »
Thanks, that helped...  sort of.
It did recognise  the unit once, then I lost
it again.  Further, the S/W is now
crashing.  I did not have these problems the
first time I used this system.
I'll start another thread.....
:-(
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.