Topic: Clear interface should CLEAR THE INTERFACE (Read 11090 times)

paul warshawsky · « **on:** November 28, 2004, 10:13:41 PM »

x10:

Clear interface should fill the entire
EEPROM with 0's (except for the header if
that is needed), not just change the header
of the eeprom to indicate that it contains
no timers or macros.

From a debugging point of view it would be
best not to have unknown data in the
interface!

Paul

Henri T · « **Reply #1 on:** November 29, 2004, 01:28:50 PM »

Hi!

I agree.

I have to remove batteries from the
interface to totaly cleared it.

andyd · « **Reply #2 on:** November 29, 2004, 02:41:43 PM »

Removing batteries clears the interface?? I
don't think so. In the past I ran without
batteries and unplugged the CM15a to reset
it after a lock up. The macros and timers
remained loaded and executed just fine
(unlil the next lockup). I'm pretty sure
the batteries power the clock and nothing
else. No power is required to retain
program in eeprom.

Andy

News:

Author Topic: Clear interface should CLEAR THE INTERFACE (Read 11090 times)

paul warshawsky

Clear interface should CLEAR THE INTERFACE

Henri T

Re: Clear interface should CLEAR THE INTERFACE

andyd

Re: Clear interface should CLEAR THE INTERFACE