Dusk conditions not working? 3.173

Started by Burdy, December 10, 2004, 01:03:21 PM

Previous topic - Next topic

Burdy

I have a trivial macro with the condition
(It's after dusk) that rings a chime if true.
Right now its 1pm, and when I run the macro
the chime rings.  If I set the condition to
(It's before dusk) the chime doesn't ring.

A similar macro with the condition (Time is
between Dusk and 11pm) executed at 1:00pm
also seems to be evaluated as true.

Am I missing something here, or is this a
known problem?

X10 Pro

Just out of curiosity, if you look at the
interface status, what are the states of
flags 15 and 16?

Burdy

Flag 15 is set, Flag 16 is clear.

It seems to act the same way whether the
macro is stored in the interface, or from
the PC.

X10 Pro


Burdy


Burdy

Also, condition (Time is between 2:00AM and
Dawn) also appears to be true, at 4:15pm.
Something seems broken here.  

arf1410


X10 Pro


Burdy

ARF, that's my point.  The macro runs as if
the condition is true.

arf1410

Oh..my macros are broken that way too...I
say an A1 only turns on a light if between 9
and 10 pm, but A1 at 10:30 pm turns lights
on.  Other macros, wont even execute
manually, and aren't even registered in the
Activity Log when I attempt to manually run
them.  I just figure about revision 4.123
would finally fix them!

arf1410

Oh..my macros are broken that way too...I
say an A1 only turns on a light if between 9
and 10 pm, but A1 at 10:30 pm turns lights
on.  Other macros, wont even execute
manually, and aren't even registered in the
Activity Log when I attempt to manually run
them.  I just figure about revision 4.123
would finally fix them!

arf1410

Oh..my macros are broken that way too...I
say an A1 only turns on a light if between 9
and 10 pm, but A1 at 10:30 pm turns lights
on.  Other macros, wont even execute
manually, and aren't even registered in the
Activity Log when I attempt to manually run
them.  I just figure about revision 4.123
would finally fix them!

arf1410

Oh..my macros are broken that way too...I
say an A1 only turns on a light if between 9
and 10 pm, but A1 at 10:30 pm turns lights
on.  Other macros, wont even execute
manually, and aren't even registered in the
Activity Log when I attempt to manually run
them.  I just figure about revision 4.123
would finally fix them!