Contact | X10.com
Please login or register.

Login with username, password and session length

Author Topic: Commands not showing in AHP  (Read 4607 times)

ron w

  • Jr. Member
  • **
  • Helpful Post Rating: 0
  • Posts: 23
Commands not showing in AHP
« on: February 28, 2005, 09:28:47 PM »
With the AHP diagnostic ver interface, it
sometimes does not send proper data back to
the AHP program. Eg: Bedroom lights are
turned on at 40% power by the interface,
however the AHP does not show the bedroom
light on at all even though the interface is
connected to the computer at all times and
the AHP program running. At times the
interface does not send any signal to turn on
a timed light. Eg. Living light over TV to be
turned on, and dimmed to 40% power, light
does not turn on at all. These problems did
not occur with the non diagnostic interface.

Logged

Dave R

  • Full Member
  • ***
  • Helpful Post Rating: 0
  • Posts: 38
Re: Commands not showing in AHP
« Reply #1 on: March 01, 2005, 12:36:22 AM »
Do U have all the proper boxes checked in U'r
timers?  How about house codes in Hardware
Config.?  Can U trigger lights On/Off from AHP?
Logged

X10 Pro

  • Hero Member
  • *****
  • Helpful Post Rating: 23
  • Posts: 1416
Re: Commands not showing in AHP
« Reply #2 on: March 01, 2005, 01:12:41 PM »
Ron W: Do the commands show up in Activity
Monitor (as opposed to changing the on screen
module)?
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.