Activity Monitor CM15A and AHP 3.199

[mike cross]

1. Pull up activity monitor, clear page.
2. minimize monitor, issue command.
3. maximize monitor, and it's there.
4. Now close the monitor and open it again
and you'll see 1000+/- duplicate commands.
5. brand new CM15A and AHP 3.199.
6. Tech support request volumes of load and
unload routines.
7 Appears that this problem has been
reported before.  No fix that I know of yet.

[eric]

I have had this problem when I programmed in
"recursive" commands.

In my case, I programmerd an RF command to
fire off when getting an E2 signal.  This RF
command was sent to a remote 751 and
instructed it to turn off the E2 lamp.  This
is a classic cyclical problem.  My lamps
would dim erratically.  This is another sign
of dualing controlers.

The point is make really sure that you don't
have any cyclical logic in your timers...
it's really-really easy to do.