📸Cameras & Camera Software > Camera General Discussion

VR36A only one code works can someone help

(1/2) > >>

AJR:
I just purchased 3 cams and the TM751 and
remote -- hooked it all up tried one code
after the other with my 5 in 1 remote, all
the cams work when I use ,house code A- unit
code -14 15 16 , but i want to switch to c 1
2 3 and it will not work . Does anyone know
why this is?
I have tried multiple combos and the input
rf signal does not respond well unless it is
on A .

WinS:
I'm familiar with the wireless cams.  They
have a little rubber plug which hides the
house code selection switches - look close.
They come defaulted to A, but can be changed
to B, C, or D.

AJR:
Cool I will test and let you know .
thank you ...

Brian H:
I think the A B C and D under the rubber
plug is the RF transmit channel back to the
receiver.

Brian H:
AJR. Have you changed the X10 Codes on the
addressable power supplies used to run the
cameras? Also remember that only one camera
should be on at any time or they will
interfere with each other. You also did
change the House Code on the TM751
Tranceiver when you changed the remote.

Navigation

[0] Message Index

[#] Next page