Please login or register.

Login with username, password and session length

Author Topic: using floodcams with VCR Commander II (UX23A)  (Read 2980 times)

sams

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 3
using floodcams with VCR Commander II (UX23A)
« on: September 12, 2005, 01:51:34 PM »

Hi all,

I currently have the wire less cam with VCR
Commander (UX21A).  Now, I'm getting 3
floodcams and the VCR Commander II
(UX23A) since it can supports 4 devices.

A question on setup.  When you set up a
motion sensor with the vcr commander, I
need to (from the instruction)

1. Press and hold PLAY on the VCR
Commander II until the red light
stays on.
2. Press the HOUSE button on the motion
sensor. The red light on the
VCR Commander will go out. This motion
sensor will now start your
VCR Commander. Point the motion sensor
away so it can’t see motion.

Now, if I use the floodcam, there is no house
button !!!

So, what do I press or what do I need to
do???

Thanks.
Logged

al

  • Full Member
  • ***
  • Helpful Post Rating: 0
  • Posts: 32
Re: using floodcams with VCR Commander II (UX23A)
« Reply #1 on: September 12, 2005, 07:56:58 PM »

Instead of pressing the button have someone
trip the floodcam motion sensor the UX23A
will use that setting.  Do that for each
floodcam.
Logged

sams

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 3
Re: using floodcams with VCR Commander II (UX23A)
« Reply #2 on: September 14, 2005, 10:10:33 AM »

AL, appreciate your input.  I'll give it a try.

Thanks again.
Logged

steve

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 3
Re: using floodcams with VCR Commander II (UX23A)
« Reply #3 on: September 15, 2005, 03:53:17 PM »

You can also temporarily change any motion
sensor to the same house/unit code as you
plan to use on the floodcam ... program
your VCR commander according to the
instructions using  the motion detector,
then set it back to whatever it was
before.  
Logged

sams

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 3
Re: using floodcams with VCR Commander II (UX23A)
« Reply #4 on: September 16, 2005, 06:47:27 AM »

Steve,

Thank you for your input.  The floodcams kit
just came two days ago.  I'll try to set them up
in the next few weeks.



Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.