Please login or register.

Login with username, password and session length

Author Topic: Power Horn  (Read 13099 times)

Screech

  • Guest
Power Horn
« on: May 17, 2004, 04:11:41 PM »

Can you hear this from the outside if it is
going off on the inside of the house?
Logged

jc

  • Jr. Member
  • **
  • Helpful Post Rating: 0
  • Posts: 13
Re: Power Horn
« Reply #1 on: May 19, 2004, 08:08:05 PM »

  Only if you place it close to an opening.
Logged

DanGi

  • Guest
Re: Power Horn
« Reply #2 on: July 13, 2004, 03:53:32 PM »

I faced the same problem.  I resolve it by
adding an X10 controlled outlet outside
near by the roof.  I attached a siren. I
set the outlet house and unit code the same
as my DS7000.  When the alarm trigger, the
siren turn on, since the DS7000 send an X-
on to remote appliance with its house and
unit code.
Logged

Judas

  • Guest
Re: Power Horn
« Reply #3 on: July 21, 2004, 07:39:44 PM »

will it the power horn sound when you arm
it o disarm it with the keychain remote?
Logged

Jim R.

  • Guest
Re: Power Horn
« Reply #4 on: July 26, 2004, 06:18:42 PM »

Does anyone have a schematic for a circuit
that will activate a Power Horn.
Thanks, Jim
Logged

Mike F.

  • Guest
Re: Power Horn
« Reply #5 on: July 30, 2004, 12:39:38 PM »

As I understand the DS7000, it only
sends "all lights on" codes when
activated.  This will not control an
Applicance module (only Lamp modules are
effected).  But I did the same thing.
Installed an outlet near the peak of my
garage (inside).  Puchased an "outdoor
rated" RadioShack power horn (12 volt), and
powered it from a 12-volt transformer
plugged into a lamp module.  The alarm
toggles on & off with the lights, and then
stays on at the end of the cycle (just like
the house lights do.

I know X10 says that Lamp modules should be
used for incandescent lights only, but it
worked just fine for me.
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.