Please login or register.

Login with username, password and session length

Author Topic: Window Switch Problem  (Read 12538 times)

patrick

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 3
Window Switch Problem
« on: June 25, 2004, 11:19:45 AM »

I have a problem with one of my windows,
specifically in that it swings "in" and
slides over with no "frame" on top to mount
the magnetic switch (frame ends up flush
with trim/drywall on the inside so
it "disappears").  This leaves only the
right hand of the window to mount the
switch, except it is a "curved handle" from
top to bottom again leaving no way to mount
the magentic switch.  Is there a "button"
switch I can install inside the frame to
trigger the sensor? If so, where can it be
obtained and are there any hints on how to
route the wire in that situation?  Ideally
I'd route the wire down within the wall as I
have a 2nd window mounted the next stud over
but doesn't go as low as this one.  In that
case, I'd love to be able to use 1 sensor
for both windows since they are nearly on
top of each other.

Thanks for any and all assistance you can
provide!


Patrick
Logged

patrick

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 3
Re: Window Switch Problem
« Reply #1 on: June 26, 2004, 02:42:43 PM »

Add to my issues a door leading to an
attached garage which opens out instead of
in.  Again finding something that I can mount
inside the door jamb would solve a lot of
headaches on this one as the magnetic mounts
don't work well  in this case either.

Thanks again!
Logged

DanGi

  • Guest
Re: Window Switch Problem
« Reply #2 on: July 13, 2004, 03:40:16 PM »

You can find on the market standard REED
switch that are meet to install within door
frame. They are usaly 1/4 inch round by 1
inch long with wire one end. They work with
a little round magnet you can glue amost
anywhere.  Just replace the X10 switch and
magnet, attach the new REED switch to the
X10 RF transmitter part using wire come
with it.
Logged

dick

  • Full Member
  • ***
  • Helpful Post Rating: 0
  • Posts: 47
Re: Window Switch Problem
« Reply #3 on: July 14, 2004, 08:26:18 AM »

As of about a year ago, Radio Shack had
these button switches in two different
sizes.
Logged

ed

  • Jr. Member
  • **
  • Helpful Post Rating: 0
  • Posts: 18
Re: Window Switch Problem
« Reply #4 on: August 05, 2004, 06:11:23 PM »

Would a motion sensor in these locations
work as well for you?  It would still
provide an alarm in the away mode, but not
in the home mode.

Ed
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.