Please login or register.

Login with username, password and session length

Author Topic: Trigger Security Console from CM11A  (Read 2665 times)

esch

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 1
Trigger Security Console from CM11A
« on: June 14, 2005, 11:39:36 PM »

OK - Is there any way to trigger my alarm
system (PS561) from my CM11A? - Can I send
it a panic or turn off or on the alarm?
Any ideas?
Logged

msimmons

  • Full Member
  • ***
  • Helpful Post Rating: 1
  • Posts: 55
Re: Trigger Security Console from CM11A
« Reply #1 on: June 15, 2005, 11:56:51 AM »

I've had this on my project list for some
time but have not gotten around to it yet.
I believe you can send 5 on & off commands
in a row to a device with the same house
code as your alarm (oops, just realised I
have the ds7000 and you have the PS561, not
sure howw different they are).
I'm not sure about stopping the alarm though.
Logged

Brian H

  • Community Organizer
  • Hero Member
  • ***
  • Helpful Post Rating: 305
  • Posts: 13260
Re: Trigger Security Console from CM11A
« Reply #2 on: June 15, 2005, 04:32:32 PM »

Not sure you can trigger the console as it
uses the RF Remotes and Detectors to be
triggered and thay use a security code in
the transmission. The Powerhorn Sirens can
be triggered by an All Lights ON All Units
OFF codes being sent repeatedly on the House
Code they are set to or the ON OFF code for
the Address they are set to. Note I did find
that my SH10A Powerhorn but not the larger
PH508 will trigger and keep sounding for
about 4 minutes if a continous set of about
5 ON codes in a row are sent on the Address
it is set to.
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.