Please login or register.

Login with username, password and session length

Author Topic: Best batteries for X-10 sensors  (Read 5676 times)

jeff

  • Full Member
  • ***
  • Helpful Post Rating: 0
  • Posts: 26
Best batteries for X-10 sensors
« on: March 29, 2005, 08:37:49 PM »

Does anybody know
Logged

loveschools

  • Jr. Member
  • **
  • Helpful Post Rating: 0
  • Posts: 19
Re: Best batteries for X-10 sensors
« Reply #1 on: March 30, 2005, 03:07:55 AM »

Well, I don't know if they are the best,
but they sure seem better, and less
expensive, in the long run, than any non-
rechargable batteries, I have ever used.

In other words, I have been very pleased
with the NiMH rechargable batteres.  They
seem to last longer on one charge than a
non-rechargable Alkaline Battery.

Several years ago, I was displeased with
NiCD rechargeable batteries, but it seems
they now have it right, with at least NiMH
2000mAh rechargeable batteries.

Some NiMH batteries can recharge in 15
minutes.  I started out using them for
Digital cameras, now I use them for almost
everything.  They last until I lose them so
far.

I hope this helps, and if someone else
knows better battery solutions they will
repsond.

Good question.

Tim  
Logged

Brian H

  • Community Organizer
  • Hero Member
  • ***
  • Helpful Post Rating: 305
  • Posts: 13260
Re: Best batteries for X-10 sensors
« Reply #2 on: March 30, 2005, 04:15:08 PM »

For real cold. Though expensive Lithiums
will go colder than others.
Logged

tony

  • Full Member
  • ***
  • Helpful Post Rating: 0
  • Posts: 35
Re: Best batteries for X-10 sensors
« Reply #3 on: March 30, 2005, 06:07:08 PM »

regular batteries typically work mine have
lasted 2 years. I would check distance
between base and sensor, could be too far or
thre is interference.
Logged

thedanc

  • Full Member
  • ***
  • Helpful Post Rating: 0
  • Posts: 43
Re: Best batteries for X-10 sensors
« Reply #4 on: March 30, 2005, 07:02:48 PM »

I found that NiMH batteries tend to sit at
about 1.3V whereas a nice, new alkaline sits
at 1.6V.  The strength of the transmitted
signal seems proportional to the available
voltage.  My transceiver cannot hear a 2.6V
(two cells) powered motion sensor, but can
hear it when it has 3.2V.
Logged

andrew

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 6
Re: Best batteries for X-10 sensors
« Reply #5 on: August 21, 2005, 06:59:36 PM »

I got a 36 pack AA energizers at home dept
for $12....
Logged

thedanc

  • Full Member
  • ***
  • Helpful Post Rating: 0
  • Posts: 43
Re: Best batteries for X-10 sensors
« Reply #6 on: August 23, 2005, 01:23:23 PM »

Yepper!  No need to get fancy with the NiMH
or NiCd. The simple throwaway alkalines have
a higher standing voltage, lower cost, and
better yet a longer shelf life.  I find that
the rechargeable cells tend to self-
discharge much faster than the low current
draw of the sensor I installed them in.  The
rechargeable cell is completely dead within
a few weeks even sitting on a shelf (but
rechargeable) whereas the throwaway alkaline
is good for 6 months so far.  "Tony" can get
2 years out of them.
Logged

kathy

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 1
Re: Best batteries for X-10 sensors
« Reply #7 on: September 24, 2005, 09:17:11 PM »

Hey, has anyone thought about solor battery
chargers? Boy, this would be great for a
power source. Please respond if you have
heard of them being used with this
application.
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.