Please login or register.

Login with username, password and session length

Author Topic: Can't get anything to turn on with AHP..  (Read 12554 times)

craig

  • Jr. Member
  • **
  • Helpful Post Rating: 0
  • Posts: 17
Can't get anything to turn on with AHP..
« on: November 13, 2005, 10:04:39 AM »

Please help!

I've had AHP for some time.  I had to
reinstall everything on my PC and now I
can't get AHP to activate anything.  I've
change house codes, everything I can think
of and nothing will turn on and off from
the interface.  Got it connected to the
module and the module plugged into a wall
outlet.  HELP!!!! I'm about ready to
through this out the window.
Logged

Brian H

  • Community Organizer
  • Hero Member
  • ***
  • Helpful Post Rating: 305
  • Posts: 13259
Re: Can't get anything to turn on with AHP..
« Reply #1 on: November 13, 2005, 03:57:44 PM »

Have you tried a complete reset. By removing
the cm15a from the wall power, remove the
batteries and wait a few minutes. Then
reconnect download and try again. Can you
control a module pluged into the same outlet
as the cm15A? When you redid the computer
was anything added like a new UPS Surge
Suppressor or Filter? If so it maybe sucking
up all the X10 Line Signals. Try without it.
Logged

roger1818

  • Hero Member
  • *****
  • Helpful Post Rating: 28
  • Posts: 1072
  • Roger H.
Re: Can't get anything to turn on with AHP..
« Reply #2 on: November 15, 2005, 06:34:32 PM »

It is also possible that the new PC itself
is interfering with the X10 signal.  I
reccomend plugging the powerbar/UPS that
your PC and accessories are plugged into,
into an X10 compatible filter.  Just make
sure that the CM15A isn't plugged into the
powerbar/UPS (you should never do that).
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.