X10 Zone > Contractor General Discussion

RS 232 CONTROL

(1/1)

milo:
Can the x10 products be used (controlled)
by an outside rs232 device
(Xantech,crestron)

Kelly Parke | Program Manager:
Milo,
Good question! Such a good question, that I
had to get the answer from our talented tech
department:

The device would have to be designed to
transmit X10 powerline carrier commands. We
offer the PL513 powerline interface for
engineers and programmers. Those users would
then take the documentation found at at the
bottom of our manuals page
http://www.x10.com/support/support_manuals.ht
m
to create software and a cable that can be
used with the interface to control X10
modules.

If you need further information, our tech
support supervisor can be reached at
support@x10.com

Navigation

[0] Message Index