Contact | X10.com
Please login or register.

Login with username, password and session length

Author Topic: AHP Controls Modules and Recognizes Remotes, but Modules not activated by Remote  (Read 6307 times)

TerGosh

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 2
AHP Controls Modules and Recognizes Remotes, but Modules not activated by Remote
« on: February 26, 2006, 04:14:10 AM »
I find the that lamp and appliance modules work fine from the ActiveHome Pro software and interface.
 
Both remotes, however, are recognized by the software (i.e., the module state correctly changes in the software screen, and indicates on / off (but not dim); however, the modules do not activate from thes remotes.
 
i.e., the Computer Interface receiver is receiving the correct remote signals (from both the Palm Pad or the SlimFire Pocket), but these signals are not being transmitted to the lamp or appliance modules.
 
But if I click the software directly, then the modules work.
 
I have already tried using a different House Code.
 
Help, please?
 
...Terry.
Logged

Brian H

  • Community Organizer
  • Hero Member
  • ***
  • Helpful Post Rating: 305
  • Posts: 13308
Re: AHP Controls Modules and Recognizes Remotes, but Modules not activated by Remote
« Reply #1 on: February 26, 2006, 07:02:01 AM »
OK try this. Tools tab; Hardware Configuration; Tranceived House Codes. Set the house codes the remotes are on to tranceived.
Logged

Tuicemen

  • Administrator
  • Hero Member
  • ****
  • Helpful Post Rating: 286
  • Posts: 10545
  • I don't work for X10, I use it successfuly!
Re: AHP Controls Modules and Recognizes Remotes, but Modules not activated by Remote
« Reply #2 on: February 26, 2006, 12:10:39 PM »
TerGosh check out this thread for some more helpful suggestions
Logged
Please Read Topic:
General Forum Etiquette
Before you post!

OBRIEN4023

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 1
Re: AHP Controls Modules and Recognizes Remotes, but Modules not activated by Remote
« Reply #3 on: December 03, 2007, 10:28:26 AM »
Quote from: Brian H on February 26, 2006, 07:02:01 AM
OK try this. Tools tab; Hardware Configuration; Tranceived House Codes. Set the house codes the remotes are on to tranceived.
Good answer...   The Transceived House Code was set to AUTO, but when I set it to my House Code, it began working immediately.  I guess I'm not sure what AUTO means, but your answer worked.  Thanks.
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.