Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[showson1]

Hi all!
Just got my starter kit and LOVE it so far.

I got the Smart Macro module and I'm trying
to set a condition where a macro will run
only if a flag is set AND the module is
currently off.

Problem is I use house code C and when I
add the module condition it only has A
codes.. I can't figure out how to set them
to C.

If anyone has any info I'd appreciate it.

Thanks!

[Brian H]

Not sure, but have you tried changing the
monitored house code to C?

[stolzb]

When you add the module, right click on the module and select "edit Module".  It will open up where
you can change the name of the module and the house/unit codes.  Hope this helps.

[emil]

As Brian mentioned, in hardware configuration set the monitored code to C.

[Chris S.]

I had the same problem.
My monitored HC is B, but I needed to check the status
of a  Lamp Module - A3 in one of my macros.

Changing the monitored HC was not an option.
What I did was created 2 Macros for the ON and OFF state of the Lamp Module on A3

Macro: Lamp ON (Trigger A3 ON)
Set Flag 2 (or whatever Flag # you want to use)


Macro: Lamp OFF (Trigger A3 OFF)
Clear Flag 2 (or whatever Flag # you want to use)


This way you maintain the ON/OFF status of your Lamp Module.

On your 3rd Macro, you check conditions of Flag 2
IF Flag 2 Set THEN  (Lamp A3 is ON)
  do this

OR

If Flag 2 Clear  (Lamp A3 is OFF)
  do this