Timer not turning lamp modules on

[kemaggard]

I have two lamp modules that will not turn on with timers on the computer(X10 Pro). The computer timers will turn them off as scheduled if I have manually flipped the switch on the computer.  Both locations did work at one time.  I have changed out both modules and still can only turn them on with computer and then the timer will turn them off as scheduled. Thanks

[steven r]

Most likely a signal problem. 1st thing to try is to move the module closer to the CM15A and see if it works.

[roger1818]

Strange that it will work from the software interface but not from a timer, but I tend to agree with Steven that it is probably a signal problem.  Check out some tutorials I wrote on Phase Coupling and Powerline Noise.

[billy]

In Timer Designer for those modules, what's the timer command line(s) read?
Also make sure "Store in Interface" is checked for each event.