When I use the MyHouse web client to view the cams at home the MyHouse status window shows the same X10 command being sent over and over again. For example turning one camera on results in an infinite loop of ON commands to that camera. If I try to turn on another camera, the Off for the previous camera is sent, then an ON for the newly requested camera but then the ON command that was in the infinite loop starts being sent again. The effect is two cameras are now on. I've attached a screen snapshot of this problem.
This is the second post about the problem. Previously another user asked if I had another transciever plugged in and I did. This seemed to resolve the problem for a while but eventually the infinite loop re-appeared. If I unplug and restart EVERYTHING the problem goes away for a few days but will eventually return.
Any help would be appreciated.
Author
Topic: Infinite Loop MyHouse Client (Read 3927 times)