X10 Community Forum

🛡Home Security => Problems and Troubleshooting => Topic started by: ramhouse on December 14, 2009, 03:39:49 PM

Title: Lm 465 module
Post by: ramhouse on December 14, 2009, 03:39:49 PM

I'm having problems with the lm 465 module, after setting alarm my light keeps coming on no matter what house code, talk to jennel at tech support, and got nothing, tryed all posible soultions and nothing, at one point i got it to stay off for 7hours but it still comes back on, help please, thanks
ramhouse

Title: Re: Lm 465 module
Post by: Brian H on December 14, 2009, 04:06:24 PM

What type of light bulb is in the light?
Are there any zones showing problems?
When you arm with delay the lights are supposed to go on for a minute then go off. Is that where the problem is for you?

Title: Re: Lm 465 module
Post by: ramhouse on December 15, 2009, 12:10:15 AM

I don't use the delay, I use a regular light bulb, any thoughts!

Title: Re: Lm 465 module
Post by: Brian H on December 15, 2009, 06:04:43 AM

Do you have the LM465 on the Security Code setting the console is set to?
Have you tried leaving the LM465 on the consoles house code but on a different unit code? That would show if an All Lights On command was being sent from maybe the console.

Title: Re: Lm 465 module
Post by: ramhouse on December 16, 2009, 01:52:26 PM

so you mean to do the opposite of the instructions, i will try different combos

Title: Re: Lm 465 module
Post by: Bill59 on December 16, 2009, 02:45:04 PM

Do you have a close neighbor with x-10?

Title: Re: Lm 465 module
Post by: dave w on December 16, 2009, 03:38:22 PM

Quote from: Bill59 on December 16, 2009, 02:45:04 PM

Do you have a close neighbor with x-10?

Or another Lamp Module you could try?

Title: Re: Lm 465 module
Post by: ramhouse on December 19, 2009, 10:49:45 PM

I have tryed all unit numbers and it keeps coming back on, any feed back!

Title: Re: Lm 465 module
Post by: Brian H on December 20, 2009, 07:23:11 AM

Did we try changing the House Code on the lamp modules only. So it doesn't match the consloes House Code. So the console should not control them at all?
Do you have any PowerFlasher Modules?

Title: Re: Lm 465 module
Post by: dave w on December 21, 2009, 10:31:57 AM

Quote from: ramhouse on December 19, 2009, 10:49:45 PM

I have tryed all unit numbers and it keeps coming back on, any feed back!

Did you try anything that has been suggested? Can't help until you start narrowing things down.

Title: Re: Lm 465 module
Post by: Brian H on December 21, 2009, 10:43:12 AM

Did you try a different House Code that is not in use by anything else?
That way it should never light. If it does. We have some deep troubleshooting to do.