I have the 5-in-1 Universal Remote programmed to change the channels on the VCR which is sending the A/V signal, and it works just fine.
I have the IR Extender emitters, both of them, secured properly right at the IR port on the VCR.
I point the remote directly at the IR port on the A/V receiver unit But the IR Extender feature does not work ???.
And, BTW, I don't know what "Powermids" are? ???
I guess the question is, do I have to program a code into the remote in order for it to work with the send/receive units? If so, how do I do that? Sorry to be so ignorant, but I have searched everywhere I know and have not seen this addressed.
Here's what I've got:
2.4GHz Wireless Audio/Video Sender Model No. VT46A
2.4GHz Wireless Audio/Video Receiver Model No. VR46A
Learning Remote Control Model UR74A
Nobody, I repeat nobody has answered the question, so here goes.
... AND the emitters must be attached directly over the IR receiving port of the device you want to control. It is best to check the port area with a flashlight to be sure it actually is the IR port.