Raspberry Pi running mochad with a CM19A.
When I
echo "rf e3 on" | nc 127.0.0.1 1099
mochad echos time Tx RF HouseUnit: E3 Func: On
but e3 does not turn on. The TM751 is about 20' away and I have a CM11A plugged in also and it doesn't see the CM19A outgoing command.
Anybody???
Thanks
cal
The TM751 is set to House Code E?
You may want to rotate the House Code Dial on the TM751 a few times. On the chance it is dirty and it is on a different House Code.
If your TM751 has the controlled outlet on it {there was a production run with a hard wired pass through outlet}. If you send an E1 On and an E1 Off. Can you control the TM751s output?