X10 Community Forum

🖥️ActiveHome Pro => ActiveHome Pro General => Topic started by: rayishome on June 11, 2006, 07:08:39 PM

Title: Run Macro Every 10 minutes
Post by: rayishome on June 11, 2006, 07:08:39 PM

I'm trying to figure out how to run a process every 10 mins.  I have a light that I want to turn off every 10 mins.  I setup a macro with a delay of 10 mins after turning the light off then sending an application modual command for the same code as the macro trigger.  This doesn't seem to work.  Any ideas.

Title: Re: Run Macro Every 10 minutes
Post by: roger1818 on June 13, 2006, 04:37:34 PM

Quote from: rayishome on June 11, 2006, 07:08:39 PM

I'm trying to figure out how to run a process every 10 mins.  I have a light that I want to turn off every 10 mins.  I setup a macro with a delay of 10 mins after turning the light off then sending an application modual command for the same code as the macro trigger.  This doesn't seem to work.  Any ideas.

Make sure the dummy module you use to send the Macro On command is an appliance module.  Lamp modules will send a series of Bright commands instead of an on command and won't trigger the macro.