Recently I converted my kitchen lights to CFL. I had been using a WS12A and companion switch to control the kitchen lights but with the change to CFL I had to change the switch. So I installed a WS14A today just as the instructions state using the neutral wires in the switch where the master is located.
The problem I am having is that when I push the master switch manually the lights work fine, the will turn on and off no problem. I can go to the slave switch and turn the lights off. I can also turn the lights off from a seperate remote keypad.
When trying to turn the lights on from the slave switch nothing happens. I get no "click" in the master, no reaction at all.
When I try to remotely turn the lights on using a keypad, the master gives me two fast "clicks" as if it is turning on and off immediately. No lights come on.
I have it wired as the diagram shows and same as when I had the WS12A in there before. Any suggestions?
Additional information: When I disconnect the control line from the master switch it operates just fine. Turns on and off manually AND via x10 remote panel.
Author
Topic: WS13A Connection (Read 2508 times)