Please login or register.

Login with username, password and session length

Author Topic: 3.201 Bugs - "Address Already Used"  (Read 4417 times)

jeffl

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 6
3.201 Bugs - "Address Already Used"
« on: February 18, 2006, 09:19:21 AM »

I decided to move my CM15A module from one
outlet to another (batteries good).  One
light module stopped turning its' lights
off. They came on with the other two
modules but didn't want to go off.  I do
have this module set to bring the
brightness on at 70%.

I decided to update the software to 3.201
before re-downloading the timer macros and
noted now that I can not add or change
modules.  When I want to edit a module and
click OK to get out of it, the message
coming back says there address is already
used.  I only have three wall switch
modules so I know that's not the case.

It seems to think it needs to be A1 even
though my selection for the module is A2.
I didn't have this issue before I
downloaded the new upgrade.

Any other ideas?
Logged

jeffl

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 6
Re: 3.201 Bugs - "Address Already Used"
« Reply #1 on: February 18, 2006, 09:27:30 AM »

Interesting, if I change the address of
module A1 to something higher, like A4 that
is not used, I can now change the other
modules.  I do not get the error address
already used.  The error message was
pointing at module A1.  When I was done
making the changes, I then set the address
on the module back to A1 and saved the room.
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.