Topic: Sending Ninja commands from macro (Read 4730 times)

teerex · « **on:** March 27, 2008, 10:04:18 PM »

Hello All:
I am trying to send commands through the AHP to my Ninja to go to a particular preset at a certain
time/day of the week and stay there for x hrs. After this period, I would like to have it start sweeping. Can
this be done using some sort of macro ? I see the commands captured in the event log when using the Ninja's
remote and the "Advanced Functions" drop down in Macro Designer has an "Extended Code" step. I don't know
which codes the various pan/tilt/sweep functions map to. FYI, I am using a non-X10 camera to record using
non-X10 capture hardware. I searched on the forum but didn't find anything relevant.

Thanks for any input/advice

teerex · « **Reply #1 on:** March 28, 2008, 06:05:42 PM »

Thanks for the response. I have sent you e-mail to the address in your sig.

Regards

teerex · « **Reply #2 on:** March 28, 2008, 08:11:31 PM »

I've sent you a PM

Thanks

News:

Author Topic: Sending Ninja commands from macro (Read 4730 times)

teerex

Sending Ninja commands from macro

teerex

Re: Sending Ninja commands from macro

teerex

Re: Sending Ninja commands from macro