Sending Ninja commands from macro

Started by teerex, March 27, 2008, 10:04:18 PM

Previous topic - Next topic

teerex

Hello All:
        I am trying to send commands through the AHP to my Ninja to go to a particular preset at a certain
time/day of the week and stay there for x hrs. After this period, I would like to have it start sweeping. Can
this be done using some sort of macro ? I see the commands captured in the event log when using the Ninja's
remote and the "Advanced Functions" drop down in Macro Designer has an "Extended Code" step. I don't know
which codes the various pan/tilt/sweep functions map to. FYI,  I am using a non-X10 camera to record using
non-X10 capture hardware. I searched on the forum but didn't find anything relevant.

Thanks for any input/advice

teerex

Thanks for the response. I have sent you e-mail to the address in your sig.

Regards

teerex


SMF spam blocked by CleanTalk