Please login or register.

Login with username, password and session length

Author Topic: Ninja Panning Prob. With Handheld Remote  (Read 4781 times)

GinaMarie

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 1
Ninja Panning Prob. With Handheld Remote
« on: January 15, 2008, 10:23:59 AM »

When I start panning the ninja with the hand held remote,  I'm unable to see anything except static on my monitor. When I stop panning the pic clears up. Anyone have the same prob.? Any suggestions?
Logged

zach1234

  • Guest
Re: Ninja Panning Prob. With Handheld Remote
« Reply #1 on: February 04, 2008, 12:14:43 AM »

If you are using a x10 camera the reason is..

The remote uses 2.4 Hz and the cameras uses 2.4 Hz.

I don't know why they made that that way but they did. Now I use wired cameras on mine.


Also you don't have yours mounted upside down outside, not in a dome enclosure?




Like I tell all feel free to email me or go to my chat at: homeautomationchat.zoomshare.com
Logged

Brian H

  • Community Organizer
  • Hero Member
  • ***
  • Helpful Post Rating: 305
  • Posts: 13295
Re: Ninja Panning Prob. With Handheld Remote
« Reply #2 on: February 04, 2008, 06:50:44 AM »

NO the pan and tilt remote uses the standard X10 310MHz to control the unit. The camera sends in the 2.4 Ghz range.
Noise could be from things like wireless networks or 2.4 Ghz phones though most would be there all the time. As you pan and tilt the camera. You are moving the sending antenna with it. It maybe a weak signal that is fading as it moves.
Logged

djern

  • Jr. Member
  • **
  • Helpful Post Rating: 0
  • Posts: 12
Re: Ninja Panning Prob. With Handheld Remote
« Reply #3 on: February 04, 2008, 11:57:27 AM »

I had the same problem with one of my ninja/camera setups.  Anytime the ninja was moving, there was only a staticy picture.  I switched the power supply with another camera not attached to a ninja and the problem cleared up.  I am guessing the power supply was somehow causing a lot of noise that was interfering with the picture.
Logged

Brian H

  • Community Organizer
  • Hero Member
  • ***
  • Helpful Post Rating: 305
  • Posts: 13295
Re: Ninja Panning Prob. With Handheld Remote
« Reply #4 on: February 04, 2008, 12:09:46 PM »

The motors making noise with the single supply for both camera and mount could be a reason for the noise on the signal. Good find.
Logged

zach1234

  • Guest
Re: Ninja Panning Prob. With Handheld Remote
« Reply #5 on: February 04, 2008, 04:42:14 PM »

Could it be that the motor is takeing all the power from the camera. Or could the motor be sending out a magnet prpblem?
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.