Thought I’d post my problem and solution and see if anyone else ever had this issue, or can explain it. Maybe I’ll solve someone else’s headache.
I have a CM11A working fine. One macro controlled several modules individually, and then had two global entries at the end. Worked fine for months.
Then I added a new, individual module, and added it to the macro. The new module was not responding to the edited macro.
The entry on the Macro Summary printout showed the new module having the same ‘All Lights On’ and ‘All Units Off’ command as the global entry above - NOT a individual ‘ON’ or ‘OFF’.
Hmmm …
So I deleted the global entries, saved, exited, then edited the macro again to add the globals back in.
Then, all worked fine, and the individual ‘ON’ or ‘OFF’ commands were properly shown on the Macro Summary printout.
I’d guess that the CM11A does not like to have individual modules added after a global. I had several macros with this same “disease”, and deleting-then-reinserting the globals (and therefore moving them to the end of the command list) fixed each one.
Just an FYI and I’m open to comments, explanations, or “hey, that happened to me too”.
