Sorry for yet another question on RF codes but I want to ensure I understand what's being sent from the MS10A security sensor as I have not used one before.
The regular X10 sensors get programmed to an X10 address, the security ones seem to just get "added" and have a unique RF code.
When I set up the MS10A I got yesterday, HG recognized it as a S-###### device and it appeared in the list of devices I could add to the dashboard. The X10 RF widget (not sure if its a device or a widget tbh) displays an alternating value of "Added S-" followed by an X10 RF Address.
images attached to show this
I also now have 2 of the S- devices appearing in my list of devices, so I added both to my Dashboard - but I only have one MS10A. Not sure why there are 2 showing, perhaps when I clicked the red button on the MS10A or the code button on the back did something ?
I have attached an image showing the 2 devices on my dashboard - one has not been updated since yesterday at 423pm (around the time I was setting it up) and the other, which I named Back Deck Sensor was updated this morning at 517am, and this is the one I believe is the one matching the MS10A now. Further, I am assuming that the RF code displayed in the X10 RF thingy is the RF code that now matches what is appearing as the Back Deck Sensor device, since the time appearing on that one matches the sensor device.
Hope this all makes sense - just trying to make sure I understand how the security sensors are sending the signal so I ensure I get it set up correctly.
