Please login or register.

Login with username, password and session length

Author Topic: Motion Sensors  (Read 8099 times)

chesh77

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 1
Motion Sensors
« on: September 21, 2006, 09:46:46 PM »

how do u find out which zone your motion sensors are on?
Logged

Puck

  • Advanced Member
  • Hero Member
  • ******
  • Helpful Post Rating: 171
  • Posts: 1799
Re: Motion Sensors
« Reply #1 on: October 12, 2006, 03:07:37 PM »

Suggestion:

First write a list of all your zones and use the list for the install order.

Then keep the list by the base for easy reference to the tripped / troubled zone.
Logged

JMac

  • Hero Member
  • *****
  • Helpful Post Rating: 23
  • Posts: 462
Re: Motion Sensors
« Reply #2 on: October 12, 2006, 03:49:22 PM »

Another suggestion:  Have a friend watch the console and note the activation of each motion sensor and then label the sensors (both at the sensor and at the console).
Logged

Rallwest

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 4
Re: Motion Sensors
« Reply #3 on: February 17, 2007, 02:49:07 PM »

The easiest way to find out which sensors are which zones is this:
1. Verify that your battery is not low.
2. Unplug your base unit from both the power and phone line.
3. Put the unit in the "RUN 2" MODE.
4. Walk around your home/office/etc. and test each unit, hitting either the TEST button on each remote or opening the door/window. (Note: Motion sensors will trigger a "ding")
5. Each window/door sensor will produce a 'ding' from the base unit while in the RUN 2 mode. The corresponding LED on the base unit for each ZONE will illuminate when triggered.

To check the motion sensors, you will have to arm the system. Following "tripping of the alarm," the LED will remain illuminated, as well as the "ARMED" LED, until you RE-ARM and then DISARM the system.
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.